Plumbing

How do I unclog a sink or disposal on Brown Friday, and when must I call a plumber?

November 18, 20265 min read

The day after Thanksgiving is the busiest day of the year for plumbers. Roto-Rooter reports about 50 percent more service calls that day than on an average Friday, and clogged kitchen sinks and jammed garbage disposals top its list of calls. The fix for most of them takes ten minutes and two things you may already own: a hex key and a plunger.

How do I unclog a sink or disposal on Brown Friday, and when must I call a plumber?

Press the reset button on the bottom of the disposal first. If it hums without turning, switch the power off and work a 1/4-inch hex key in the socket underneath until the plate turns freely, then press reset again. If the disposal runs but water stands in the sink, the clog is in the drain, not the disposal.

Brown Friday falls on Friday, November 27 in 2026, and plumbers are booked solid that day. Service Experts reported a 15 percent increase in plumbing calls on the Friday after Thanksgiving in 2025, so a ten-minute fix at home can save you a long wait and a holiday service charge. The steps below work in order, and each one tells you when to stop.

Is the disposal jammed, or is the drain clogged?

Flip the switch and listen before you touch anything. A hum with no grinding means the motor has power but the plate is stuck. Silence after the unit tripped means the thermal overload switch cut the power. Both point to a jam in the disposal. A disposal that runs and grinds while water stays in the sink points to a clog in the drain past the disposal, and water rising in the other side of a double sink points the same way. The hex key fixes a jam. The plunger, the trap, and a drain snake fix a clog, and mixing up the two wastes the morning.

Our guide to keeping the disposal from clogging on Thanksgiving covers what should never have gone down it in the first place. If the failure happened on the day itself, our Thanksgiving Day triage guide covers the oven and the furnace too.

How to free a jammed disposal with the reset button and hex key

Most disposals ship with a small hex key, and a standard 1/4-inch Allen wrench fits the socket on many models. Work through the steps in order. The hex key comes before the reset button, because the overload switch tripped for a reason: the motor could not spin.

  1. Turn the wall switch off, then switch off the breaker for the disposal circuit. Wait 3 to 5 minutes for the motor to cool. The reset button will not stay in while the thermal switch is still hot, according to plumber guidance.
  2. Find the hex-shaped socket in the center of the bottom of the unit. Insert the hex key and work it back and forth in short turns until the plate breaks free and turns a full rotation.
  3. Remove the key. If you can see the object through the drain opening, pull it out with long tongs or needle-nose pliers. Never put a hand inside the disposal, even with the power off.
  4. Press the red reset button on the bottom of the unit until you feel it click. That click means the internal overload switch has reset.
  5. Restore power, run cold water, and switch the disposal on. Let the cold water run for about 30 seconds after the grinding stops, so the loosened debris flushes past the trap.

If the key will not turn the plate even with firm pressure, stop. Forcing it can break the internal mechanism, and a seized disposal needs a plumber. The same applies if the disposal hums again right after you clear it, or if the reset button pops out the moment you switch it on. That cycle overheats the motor, and a humming motor draws heavy current and can be damaged beyond repair in under a minute, according to plumber guidance.

How to clear a clogged kitchen sink

If the disposal runs, the problem is downstream, so start with the plunger and work toward the wall. Use a flat-bottomed sink plunger, not a toilet plunger. Block the other side of a double sink with a wet rag or a stopper so the pressure goes into the clog instead of up the other drain, keep enough water in the sink to cover the cup, and plunge up and down in short, firm strokes. If the water starts to move, run the disposal with cold water to flush what is left.

If the plunger does not move it, the clog is probably in the P-trap, the curved pipe under the sink. Bail out the standing water, put a bucket under the trap, and unscrew the slip nuts by hand. Empty the trap into the bucket, clear out the packed food, and reassemble it before you run water. If the trap is clear and the sink still will not drain, the clog is further down the line. A hand-crank drain snake into the wall pipe is the next step, and if that does not reach it, call a plumber. Our guide to a slow drain versus a sewer line problem covers the signs that the clog is past the kitchen entirely.

When to call a plumber on Brown Friday

Plumbers charge holiday rates and run long waits on Brown Friday, so it helps to know which symptoms are worth the call and which ones you can close out yourself. The table below is the decision list.

SymptomTry it yourselfCall a plumber
Disposal hums, hex key frees the plateYes. Reset, test with cold water, and watch it for a day.If it hums again right after you clear it.
Flywheel will not turn with the hex keyNo. Stop before you force it.Yes. A seized unit or a foreign object in the chamber.
Reset button pops out every time you switch onNo. The jam is still there.Yes. The motor is straining against something it cannot clear.
Breaker trips on every useNo. Leave the breaker off.Yes. A short circuit or a seized motor needs a technician.
Water backs up in both sides, or in other fixturesPlunger and trap only.Yes, if the trap is clear. The clog is past the kitchen.
Leak from the bottom of the unit or the mounting ringNo. Do not run it.Yes. A leaking disposal is a replacement or a pro repair.

A disposal near the end of its life is the other call to weigh. A disposal lasts about 12 years, according to the appliance life-expectancy table published by This Old House. If yours is that age and it has jammed more than once this year, a replacement costs less than a holiday emergency visit followed by another jam in a month.

What not to do with a clogged sink or disposal

Do not hold the switch on while the motor hums. A humming motor draws heavy current and overheats in under a minute, according to plumber guidance, and the heat can damage the motor beyond repair. Switch it off right away and move to the hex key. Do not keep pressing the reset button and flipping the switch in a loop. Each cycle strains the motor again without clearing the jam. Do not pour chemical drain cleaner into a standing sink. It does not dissolve a packed food clog, it sits in the trap, and it makes the repair messier and riskier for the plumber who opens the drain. And do not put a hand inside the disposal for any reason, even with the power off and the plug pulled.

Contested

Chemical drain cleaner will clear a Brown Friday clog

It will not. The clog is a packed mass of grease, starch, and food scraps sitting in the trap or the drain, and drain cleaner does not dissolve that kind of blockage. It pools in the standing water, it does nothing to the mass, and the caustic liquid stays in the pipe for whoever opens it next. A plunger or a cleared trap does the actual work, and both cost less than the bottle.

Before you forget

Write it down while it’s fresh

The practical way to keep this record is an app that holds the task, the dates, and the next check together. If you track home maintenance in the Homwarden app, the disposal install date, the last jam, and the next check each live as dated entries, so next Thanksgiving starts from a record instead of from memory.

  • The disposal model and install date, from the label on the unit
  • The date of the last jam, and what caused it
  • The plumber visit date and what was cleared, if one was needed
  • The age of the unit against its expected 12-year life

This is the part almost everyone skips, and it’s the part that pays. The next time this happens — or when a warranty claim, an insurance adjuster, or a buyer’s inspector asks — the answer is already written down. That is what homwarden is built to hold: maintenance, appliances, warranties, receipts, and records, filed with the equipment they belong to.

Common questions

What is Brown Friday?

Brown Friday is the day after Thanksgiving, and plumbers call it the busiest day of their year. Roto-Rooter reports about 50 percent more service calls that day than on an average Friday, with clogged kitchen sinks and jammed garbage disposals at the top of the list. In 2026, Brown Friday falls on Friday, November 27.

Why does my garbage disposal hum but not grind?

A hum with no grinding means the motor has power but the plate is jammed, usually by a bone, a fruit pit, or a piece of hard food wedged against the shredder ring. Switch the power off, work a 1/4-inch hex key in the socket on the bottom until the plate turns freely, remove the key, press the red reset button, and test with cold water running. If the plate will not turn, call a plumber.

How do I know if the clog is in the disposal or the drain?

Flip the switch and listen. A hum with no grinding, or silence after the unit tripped, points to a jam in the disposal. A disposal that runs and grinds while water stands in the sink points to a clog in the drain past the disposal. Water rising in the other side of a double sink also points to the shared drain, not the disposal.

Can I use chemical drain cleaner on a clogged kitchen sink?

No. Chemical drain cleaner does not dissolve a packed food clog, it sits in the trap and in the standing water, and it makes the repair messier and riskier for the plumber who opens the drain. A plunger, a cleared P-trap, or a drain snake does the actual work.

When should I call a plumber instead of fixing it myself?

Call a plumber if the hex key cannot turn the flywheel, if the reset button pops out every time you switch the disposal on, if the breaker trips on every use, if the disposal leaks from the bottom or the mounting ring, or if the sink still will not drain after you have cleared the trap. Water backing up into other fixtures also needs a plumber.

General maintenance guidance only. It is not a substitute for an inspection, a licensed contractor, an engineer, your insurer, the manufacturer’s instructions, or local code. When the stakes are gas, fire, structure, or standing water near electricity, stop and call a professional.