Safety

How do I use my fireplace safely the first time this season?

November 9, 20265 min read

The first fire of the season is the one that tests everything you ignored all summer. A chimney that sat unused for months can hold a bird nest, a stuck damper, or a winter of creosote buildup from last year. The National Fire Protection Association reports an estimated annual average of 37,365 home heating equipment fires from 2020 through 2024, and 46 percent of them happened in December, January, and February. A short check before the first fire keeps the season from starting with a scare.

How do I use my fireplace safely the first time this season?

Confirm the annual chimney inspection is done, clear three feet around the hearth, check that the damper opens fully, and test the smoke and carbon monoxide alarms before you light anything. If the inspection is not done yet, book it now and wait for the sweep before the first fire.

The numbers behind the advice come from the National Fire Protection Association and the U.S. Fire Administration. The National Fire Protection Association reported in its January 22, 2026 release that fire departments responded to an estimated annual average of 37,365 home heating equipment fires from 2020 through 2024, with 46 percent falling in December through February. The U.S. Fire Administration reported that heating was the second leading cause of home fires in 2021, with an estimated 32,200 home heating fires reported to U.S. fire departments, causing an estimated 190 deaths, 625 injuries, and $442 million in property loss. The first fire is worth a checklist because the season it opens is the riskiest stretch of the year.

Pre-first-fire checklist

Work through this list once, in order, before the first fire. It follows guidance from the National Fire Protection Association and the U.S. Fire Administration, and it takes about half an hour if the inspection is already done.

  1. Confirm this year's chimney inspection is done. If it is not, book a certified sweep now. Sweeps get busy once the cold arrives, and a fireplace should not run until the inspection is complete.
  2. Check the damper. It should open and close fully and smoothly. A damper stuck shut fills the room with smoke, and a damper stuck open is a chimney-sized hole in the house all winter.
  3. Shine a flashlight up the flue. Look for sticks, leaves, and nesting material. If you see debris, do not try to burn it out. Call a sweep.
  4. Look for creosote on the flue walls. The Chimney Safety Institute of America says to sweep a masonry fireplace at 1/8 inch of sooty buildup, and sooner if there is any glaze. Creosote can be crusty and flaky, tar-like and sticky, or shiny and hardened, and every form is highly combustible.
  5. Check the chimney cap and crown from the ground. A missing cap lets rain and animals in, and a cracked crown lets water into the masonry.
  6. Clear three feet around the fireplace. Move rugs, blankets, firewood racks, and furniture out of the zone, and confirm the glass or metal screen is in place and undamaged.
  7. Test the smoke and carbon monoxide alarms. A fireplace that is not venting properly can send carbon monoxide into the room, so working alarms are part of the fireplace check. Replace batteries now if the test is weak.
  8. Stock seasoned hardwood only. The U.S. Environmental Protection Agency's Burn Wise program recommends wood under 20 percent moisture, tested with a moisture meter. Wet wood and softwoods like pine build creosote far faster.

Our guide to a chimney inspection before winter covers what the inspection itself looks at and when a deeper Level 2 inspection applies, such as after a chimney fire or when buying or selling a home.

What the three chimney inspection levels mean

Chimney inspections come in three levels under the NFPA 211 standard. Knowing which one you need keeps you from paying for more than the situation calls for, or from skipping a check the situation needs. Most homeowners running the same fireplace they ran last year need a Level 1 as the annual baseline.

LevelWhat it coversWhen you need it
Level 1Visual check of readily accessible interior and exterior partsYour annual inspection, when nothing has changed
Level 2Deeper look at accessible flue and chimney sections, often with a cameraAfter a system change, a malfunction, a chimney fire, a storm or earthquake, or when buying or selling a home
Level 3Comprehensive check including hidden parts, which may require removing componentsWhen a serious hidden hazard is suspected

Setting up the hearth for the season

The U.S. Fire Administration keeps its fireplace guidance short, and each rule answers a specific way fires start. Keep anything that can burn at least 3 feet from the fireplace or wood stove. Use a glass or metal screen in front of the fireplace so embers and sparks cannot jump out. Do not burn paper in the fireplace, since paper can lift on the draft and carry embers up the flue. Keep the fire small enough that the screen stays between the flames and the room, and never leave a fire burning when you go to bed or leave the house.

Ashes deserve the same care as the fire. Let them cool completely, then put them in a metal container with a lid and keep the container outside, at least 10 feet from the house. Ashes can hold heat for days, and a container stored on a wood deck or in the garage is a fire waiting for a gust. If you are unsure whether the ashes are cool, wait another day before moving them.

Contested

An inspection is annual, a sweep is conditional

The inspection happens every year, and the sweep happens when the inspection finds buildup worth removing. That split is the point most homeowners miss. A fireplace that burned little last year may pass inspection with no sweep, while a fireplace that burned wet wood all winter may need a sweep well before the 1/8 inch mark. Paying for the inspection every fall is what tells you which case you are in, and skipping it means guessing about the one part of the house that carries open flame up through the roof.

Before you forget

Write it down while it’s fresh

The record is what makes the annual cycle stick, because nobody remembers an inspection done eleven months ago. A home management app is the practical place to keep it, with the inspection date and the sweep report saved next to the fireplace itself. If you track home maintenance in the Homwarden app, the inspection becomes a dated entry with a reminder for next fall, so the check happens before the first fire instead of after a scare. Our guide to cleaning your dryer vent each fall follows the same yearly rhythm for the other fire risk in the house.

  • The date of this year's chimney inspection and the name of the sweep
  • The inspection level and anything the sweep flagged, such as creosote glaze or a cracked crown
  • The date of the last sweep and the buildup the sweep reported
  • The date you tested the smoke and carbon monoxide alarms
  • Where you buy seasoned hardwood and the moisture reading, if you test it

This is the part almost everyone skips, and it’s the part that pays. The next time this happens — or when a warranty claim, an insurance adjuster, or a buyer’s inspector asks — the answer is already written down. That is what homwarden is built to hold: maintenance, appliances, warranties, receipts, and records, filed with the equipment they belong to.

Common questions

Do I need my chimney inspected before the first fire of the season?

Yes. The national standard NFPA 211 calls for chimneys, fireplaces, and vents to be inspected at least once a year for soundness, freedom from deposits, and correct clearances. The U.S. Fire Administration gives the same advice in plainer words: have heating equipment and chimneys cleaned and inspected each year by a professional. Book the inspection in the fall, before heating season starts.

How do I know if my chimney needs sweeping?

The Chimney Safety Institute of America recommends sweeping a masonry fireplace once sooty buildup reaches 1/8 inch, and sooner if any glazed creosote is present. Creosote is the flammable residue wood smoke leaves on the flue walls, and it can look crusty and flaky, tar-like and sticky, or shiny and hardened. Every form is combustible, so a shiny glaze means sweep now instead of waiting for the 1/8 inch mark.

How far should furniture and rugs be from the fireplace?

Keep anything that can burn at least 3 feet from the fireplace or wood stove, according to the U.S. Fire Administration. That includes rugs, blankets, firewood racks, furniture, and anything drying near the heat. A glass or metal screen in front of the fireplace keeps embers and sparks from jumping into the room.

What kind of wood should I burn in my fireplace?

Burn only seasoned, dry hardwood. The U.S. Environmental Protection Agency's Burn Wise program recommends wood with less than 20 percent moisture, tested with a wood moisture meter. Wet or green wood and softwoods like pine produce far more creosote, far faster, which shortens the time between sweeps and raises the chimney fire risk.

How do I dispose of fireplace ashes safely?

Let the ashes cool completely, then put them in a metal container with a lid and keep the container outside, at least 10 feet from the house. The U.S. Fire Administration gives this distance in its fireplace safety guidance. Never put ashes in a paper bag or a plastic bin, and never store the metal container on a wood deck or in the garage while the ashes are still warm.

General maintenance guidance only. It is not a substitute for an inspection, a licensed contractor, an engineer, your insurer, the manufacturer’s instructions, or local code. When the stakes are gas, fire, structure, or standing water near electricity, stop and call a professional.