What should I check when the clocks go back?
Daylight saving time ends on Sunday, November 1, 2026, at 2 a.m., when clocks in Dallas-Fort Worth fall back one hour. Fire services have used that date for years as the reminder to test smoke and carbon monoxide alarms, because the check is easy to remember and easy to put off. This walkthrough covers every alarm in the house in one pass, plus the monthly reminder that keeps the check from slipping again.
What should I check when the clocks go back?
Press the test button on every smoke alarm and carbon monoxide alarm, change the batteries in any alarm that takes replaceable batteries, and replace any smoke alarm that is more than 10 years old. Check the date printed on the back of each alarm, confirm placement on every level and outside sleeping areas, and set a monthly test reminder.
The stakes behind that short routine are high. The National Fire Protection Association reports that almost three out of five home fire deaths happened in homes with no smoke alarms or no working smoke alarms. A dead battery is the most common reason a working alarm stops working: the National Fire Protection Association reports that 71 percent of smoke alarms that failed to operate in a fire had missing, disconnected, or dead batteries.
How do I walk the house alarm by alarm?
Work room by room so no alarm is skipped, and bring fresh batteries in the sizes your alarms take. If an alarm is hardwired, it still has a backup battery to check, and if it is a sealed 10-year unit, it still gets a test even though its battery never comes out.
- Press and hold the test button on each alarm until it sounds, then release it and confirm it stops. If alarms are interconnected, one test should set off the others, which confirms the link between them still works.
- Change the batteries in every alarm that takes replaceable batteries, even if it passed the test. The U.S. Consumer Product Safety Commission advises replacing batteries at least once a year, and the clock change is the date that makes the habit stick.
- Turn each alarm over or unclip it from its base and read the manufacture date printed on the back. Replace any smoke alarm that is more than 10 years old, and replace any carbon monoxide alarm that has passed the service life its manufacturer states, commonly 5 to 7 years.
- Check placement while you are at each alarm. Smoke alarms belong inside each bedroom, outside each sleeping area, and on every level of the home including the basement, according to the National Fire Protection Association. Carbon monoxide alarms belong on every level and outside each sleeping area, according to the U.S. Consumer Product Safety Commission.
- Vacuum dust from each alarm cover with a soft brush attachment, since dust on the sensor can delay a response. Do not paint over an alarm, and do not cover its vents with tape or decorations.
- Write down the age and battery date of every alarm, and set a monthly test reminder for the same day each month. The record turns next spring's clock change into a quick retest instead of a fresh round of guesswork.
What type of alarm do I have, and when does it expire?
The table below covers the alarm types found in most homes. The replacement ages come from the National Fire Protection Association and the U.S. Fire Administration for smoke alarms, and from manufacturer guidance for carbon monoxide alarms.
| Alarm type | Where it goes | Test and replacement schedule |
|---|---|---|
| Battery-powered smoke alarm | Inside each bedroom, outside each sleeping area, and on every level | Test monthly, change batteries at least once a year, replace the unit at 10 years |
| Sealed 10-year battery smoke alarm | Inside each bedroom, outside each sleeping area, and on every level | Test monthly, no battery to change, replace the whole unit at 10 years |
| Hardwired smoke alarm with battery backup | Inside each bedroom, outside each sleeping area, and on every level | Test monthly, change the backup battery at least once a year, replace the unit at 10 years |
| Carbon monoxide alarm | On every level and outside each sleeping area | Test monthly, change batteries at least once a year where applicable, replace on the manufacturer schedule, commonly 5 to 7 years |
| Combination smoke and carbon monoxide alarm | On every level and outside each sleeping area | Test monthly, follow the battery rule for its type, replace at 10 years for the smoke sensor and on the manufacturer schedule for the carbon monoxide sensor |
If a combination alarm reaches 10 years, replace it even if the carbon monoxide sensor seems fine, because the smoke sensor has reached its stated life. When buying a replacement, match the type that was there, so a hardwired alarm is replaced with a hardwired alarm and an interconnected set stays interconnected.
Why does the carbon monoxide check matter most in November?
November opens the four months the U.S. Consumer Product Safety Commission identifies as the top months for carbon monoxide poisoning deaths. Nearly two-thirds of non-fire carbon monoxide deaths occur from November through February, and the Commission reports that carbon monoxide kills more than 400 people per year in the United States. Heating equipment starts running in November in Dallas-Fort Worth, and a cracked heat exchanger or a blocked flue can send carbon monoxide into living space with no smell and no visible warning.
If a carbon monoxide alarm sounds, get everyone out of the house into fresh air and call 911 from outside. Do not go back inside to open windows or to silence the alarm, and do not assume the alarm is faulty without a fire department check. The same rule applies to a smoke alarm that sounds at night: get out first, then call for help from outside.
What should I do when an alarm fails the test?
An alarm that stays silent after a fresh battery is finished, and it should be replaced the same day rather than left on the ceiling as a placeholder. An alarm that chirps between tests usually needs a battery, and our guide to a chirping smoke detector walks through the causes in order. A sealed unit that keeps chirping after testing has reached the end of its service life, and the whole unit goes.
Buy replacements before removing the old alarms, so no bedroom spends a night unprotected. Keep the receipt and the manufacture date with the alarm record, since the next replacement date counts from manufacture, not from the day the box was opened.
One test a year is not a maintenance plan
The clock change gets the alarms tested twice a year at most, and that gap is where the risk sits. A national survey conducted for the National Fire Protection Association Fire Protection Research Foundation found that 61 percent of households test their alarms less often than the recommended monthly schedule, and 33 percent said they never test them. A monthly reminder closes that gap with one button press per alarm.
Pair the alarm check with the rest of the heating-season sequence. Our guide to a furnace tune-up before winter in Texas covers the heating equipment the carbon monoxide alarm guards, and our first freeze checklist for Dallas-Fort Worth puts the alarm test in order against the November 22 average first freeze from the National Weather Service Fort Worth.
Write it down while it’s fresh
The practical way to keep this record is an app that holds the task, the dates, and the next check together. That record is exactly what a home management app is for, and if you track home maintenance in the Homwarden app, the alarm ages, the battery dates, and the monthly test each live as dated entries, so next spring starts from a record instead of from memory.
- The manufacture date and install date of every smoke and carbon monoxide alarm
- The battery type and the date batteries were last changed in each alarm
- The placement of each alarm, by room and level
- The date of the last monthly test, and the date the next test is due
This is the part almost everyone skips, and it’s the part that pays. The next time this happens — or when a warranty claim, an insurance adjuster, or a buyer’s inspector asks — the answer is already written down. That is what homwarden is built to hold: maintenance, appliances, warranties, receipts, and records, filed with the equipment they belong to.
Common questions
What should I check when the clocks go back?
Test every smoke alarm and carbon monoxide alarm by pressing its test button, change the batteries in any alarm that takes replaceable batteries, and replace any smoke alarm that is more than 10 years old. Confirm that alarms are installed on every level of the home and outside each sleeping area, then set a monthly test reminder.
How often should I test my smoke alarms?
Test every smoke alarm and carbon monoxide alarm at least once a month by pressing the test button, according to the National Fire Protection Association and the U.S. Consumer Product Safety Commission. A monthly test is the only way to know an alarm still sounds, since a silent alarm looks exactly like a working one.
How old is too old for a smoke alarm?
Replace a smoke alarm 10 years after its manufacture date, which is printed on the back of the unit. The National Fire Protection Association and the U.S. Fire Administration both give 10 years as the replacement point, and changing the battery does not extend the life of an alarm past that age.
Where should carbon monoxide alarms go in a home?
Install a carbon monoxide alarm on every level of the home and outside each sleeping area, following U.S. Consumer Product Safety Commission guidance. Homes with gas appliances, a fireplace, or an attached garage need carbon monoxide alarms, and the alarms should never be installed only in the room with the appliance.
Do sealed 10-year smoke alarms need new batteries?
No. A sealed 10-year smoke alarm has a battery that is built in for the life of the unit, so there is nothing to change. Test it monthly like any other alarm, and replace the whole unit when it reaches the end of its service life or when it chirps and will not stop after testing.
General maintenance guidance only. It is not a substitute for an inspection, a licensed contractor, an engineer, your insurer, the manufacturer’s instructions, or local code. When the stakes are gas, fire, structure, or standing water near electricity, stop and call a professional.