Safety

How do I winterize my home? The November checklist

November 2, 20266 min read

November is the month to winterize, because the work has a deadline set by weather rather than by habit. A hard freeze can arrive with a few days of warning, and the tasks that prevent burst pipes and a dead furnace on a cold night take an afternoon when done early and an emergency call when done late. This checklist puts the freeze-sensitive work first and ties every deadline to the forecast for your area.

How do I winterize my home?

Work through heating, pipes, drafts, roof drainage, and outdoor water before the first hard freeze in your area, and finish the outdoor water and pipe insulation first because those fail first in a freeze. Test the heat, insulate exposed pipes, seal the worst drafts, clean the gutters, and disconnect hoses.

The cost of skipping the pipe work is documented in insurer data. State Farm data reported for January 2024 through June 2025 shows more than 20,000 frozen and winter water-damage claims in that period, with more than 628 million dollars paid and an average claim payment above 30,000 dollars. That figure covers frozen and winter water damage claims in the State Farm data for that date range, and it is the reason pipe insulation sits at the top of this list rather than at the end.

When should each task be done?

Use your local forecast and the average first freeze date for your location from the National Weather Service, since first freeze dates vary widely across the country. A checklist tied to one region would mislead a homeowner somewhere else, so the table below uses weather milestones instead of calendar dates.

DeadlineTasks to finish by then
Before the first hard freeze is forecastDisconnect every hose, drain outdoor faucets, cover outdoor faucets, insulate pipes in unheated spaces, drain irrigation lines and protect the backflow preventer, and locate the main water shutoff
Before the first sustained cold snapTest the heating system under load, change the furnace filter, seal the worst drafts, clean the gutters after most leaves have fallen, inspect the chimney before the first fire, and test smoke and carbon monoxide alarms
Before holiday guests arriveRun the heating system for a full cycle, confirm warm air at every vent, clear slow drains, check the water heater setting, and confirm the guest rooms hold heat overnight

How do I test the heating system before I need it?

Run the heat while the weather is still mild. Set the thermostat several degrees above the room temperature, let the system run for 15 to 20 minutes, and walk the house to confirm warm air at every vent. A system that sat idle for months can fail on a dirty flame sensor, a cracked ignitor, or a strained blower, and finding that fault in November leaves time for a scheduled repair. Our guide to a furnace tune-up before winter covers what a technician checks on that visit.

Change the filter as part of the test. The U.S. Department of Energy advises checking the heating filter monthly and replacing it at least every 3 months, and a clogged filter restricts airflow enough to shut a furnace down on its safety limit. If the furnace is older, was skipped last year, or shows any fault during the test, book a professional tune-up: an Angi estimate puts a pre-season tune-up at 70 to 200 dollars, which is the range to expect rather than a quoted price.

Heating season is also carbon monoxide season. The U.S. Consumer Product Safety Commission identifies November through February as the top months for carbon monoxide poisoning deaths, with nearly two-thirds of non-fire carbon monoxide deaths occurring in those four months, and reports that carbon monoxide kills more than 400 people per year in the United States. Test every smoke alarm and carbon monoxide alarm as part of the winterize pass, using our guide to what to check when the clocks go back. If a carbon monoxide alarm sounds, get everyone outside and call 911 from outside.

Which pipes and outdoor water need protection first?

Start with the pipes most exposed to cold air: supply lines in garages, attics, and crawl spaces, pipes on exterior walls, and every outdoor faucet. Foam sleeves on those runs are cheap and sold at any hardware store, and a run that froze in a previous winter earns heat cable under the sleeve. Our guide to preventing frozen pipes walks through the room-by-room version of this check.

Outdoor water fails before indoor plumbing does, because it has no heated space around it. Disconnect every hose, since a hose left connected traps water against the faucet and defeats a frost-free faucet. Drain the irrigation system and protect the backflow preventer, which sits exposed and freezes early. Inside the house, know where the main water shutoff is before a pipe bursts, and keep the thermostat at 55 degrees Fahrenheit or higher in an occupied home. On a hard freeze night, open under-sink cabinets on exterior walls and let a faucet on an exterior wall drip, so cold air and still water stop combining in the same pipe.

Where do drafts and heat loss matter most?

Seal the gaps that move the most air first: worn weatherstripping on exterior doors, gaps where window trim meets the wall, and gaps around pipe and cable penetrations. Secondary sources quoting the U.S. Department of Energy put air sealing savings at 10 to 20 percent of heating and cooling costs, and that figure is an estimate attributed to the U.S. Department of Energy through those secondary sources rather than a measured result for any single home. The draft test costs nothing: hold a hand near a door or window edge on a windy day, and replace the weatherstripping or add a door sweep where cold air comes through.

Check the attic while the weather is mild. Insulation should cover the attic floor evenly with no bare spots, and the U.S. Department of Energy recommends R-38 to R-60 for most attics. If ceiling joists show through the insulation, the attic is under-insulated, and that gap raises heating bills all winter while also letting warm air escape into the roof assembly. Set ceiling fans to turn clockwise on low speed for winter, which the U.S. Department of Energy recommends to push warm air pooled at the ceiling back down into the living space.

What about the roof, gutters, and chimney?

Clean the gutters after most leaves have fallen and before sustained cold weather, so water drains away from the house instead of pooling at the foundation or backing up at the roof edge. An Angi estimate puts professional gutter cleaning at 120 to 230 dollars, which is the range to expect for a typical single-story home rather than a quoted price. While the gutters are clear, look for lifted shingles and failed flashing from the ground, and leave roof walking to a professional.

Have a wood-burning chimney inspected before the first fire of the season. The National Fire Protection Association standard known as NFPA 211 calls for chimneys, fireplaces, and vents to be inspected at least once a year, and cleaned when deposits require it. Close the damper when no fire is burning, since an open damper sends heated air straight up the chimney all winter.

Contested

Winterizing is a deadline, not a single weekend project

The argument online is whether winterizing belongs in one big fall weekend or spread across the season. One big weekend sounds tidy, and it fails in practice because the outdoor water work cannot wait for a free Saturday once a freeze is forecast. The deadline table above resolves that tension by splitting the work: outdoor water and pipes go first on a weather deadline, while heating, drafts, and gutters follow on the cold snap deadline.

The same split applies to hiring. A furnace tune-up, a chimney inspection, and a gutter cleaning can all be booked in November at ordinary rates, while the same three jobs booked after the first freeze compete with emergency calls. Doing the homeowner tasks early is what keeps the hired tasks on a schedule you choose.

Before you forget

Write it down while it’s fresh

The practical way to keep this record is an app that holds the task, the dates, and the next check together. If you track home maintenance in the Homwarden app, the filter change, the pipe insulation, the gutter cleaning, and the alarm ages each live as dated entries, so next November starts from a record instead of from memory.

  • The date the heating system was tested and the date the filter was last changed
  • Which pipes were insulated and where the main water shutoff is
  • The date the gutters were cleaned and the chimney was last inspected
  • The manufacture dates of every smoke and carbon monoxide alarm

This is the part almost everyone skips, and it’s the part that pays. The next time this happens — or when a warranty claim, an insurance adjuster, or a buyer’s inspector asks — the answer is already written down. That is what homwarden is built to hold: maintenance, appliances, warranties, receipts, and records, filed with the equipment they belong to.

Common questions

How do I winterize my home?

Work through heating, pipes, drafts, roof drainage, and outdoor water before the first hard freeze in your area, and finish the outdoor water and pipe insulation first because those fail first in a freeze. Test the heat, insulate exposed pipes, seal the worst drafts, clean the gutters, and disconnect hoses.

When should I winterize my home?

Finish the outdoor water and pipe work before the first hard freeze is forecast in your area, and finish the heating test, draft sealing, and gutter cleaning before the first sustained cold snap. The National Weather Service publishes average first freeze dates by location, and those dates vary widely by region, so use your local forecast and local normals rather than a single national date.

Which pipes freeze first?

Pipes in unheated spaces freeze first: pipes in garages, attics, crawl spaces, and on exterior walls, plus outdoor faucets and irrigation parts. The Insurance Institute for Business and Home Safety notes that pipes can freeze and burst at 20 degrees Fahrenheit or below, which is why insulation in those spots comes before cosmetic winter work.

What temperature should I keep the heat at in winter?

Keep the thermostat at 55 degrees Fahrenheit or higher in an occupied home, following freeze-prep guidance from the Insurance Institute for Business and Home Safety. Letting an occupied house drop below that level during a cold snap leaves pipes in exterior walls and unheated spaces exposed to freezing temperatures.

Do I need a professional furnace tune-up before winter?

A professional tune-up is worth booking if the furnace is older, was skipped last year, or shows any fault, and an Angi estimate puts a pre-season tune-up at 70 to 200 dollars. A homeowner can still test the heat, change the filter, and clear the vents first, and that test is what catches a dead system while repair scheduling is still easy.

General maintenance guidance only. It is not a substitute for an inspection, a licensed contractor, an engineer, your insurer, the manufacturer’s instructions, or local code. When the stakes are gas, fire, structure, or standing water near electricity, stop and call a professional.